Settings And Adjustments - Life & Mobility Solo Gebrauchsanweisung

Product description
Freewheel sticker (see also page 27)
The sticker above the freewheel lever (J)
indicates the "push position". In this setting the
mobility scooter can be moved freely.
The sticker below the free­wheel lever indicates
that the mobility scooter is ready to be
electrically driven.
Battery connection diagram
The battery connection diagram is located on
the inside of the battery cover (I). It also includes
the fuse and the motor controls.
GB18
I J
Change seat height
Push position
Electric driving position
Change seat depth
Change back angle
You can set up the mobility scooter to meet
all your requirements. It is advisable to contact
your dealer for the correct settings.
T
Adjusting the seat
Seat height
1. Move the lever (T) upwards (it is located on
2. Release the lever (T).
Seat depth
Attention
ƒ
1. Operate the lever (Q2)*.
2. Slide the seat forwards/backwards.
Q2
3. Release the lever, the slide system will click
Back angle
Attention
ƒ
ƒ
S
1. Sit down on the seat
2. Lift the lever (S).
* This is located on the left or right­hand side, depen­
ding on the configuration of your mobility scooter.

Settings and adjustments

the left­hand or right­hand side of the seat,
depending on the configuration chosen).
The seat will go down if you are sitting in it.
The seat will go up if unoccupied.
The seat is now locked in its current position.
Your centre of gravity will change if you use
the slide system to change the seat position.
You should be aware of this, especially if you
are riding up a slope.
Attention: do not confuse this with the seat
height lever (T).
into the locking mechanism.
Only adjust the backrest when you are sitting
in the seat.
The maximum back angle (180°) is only
intended for transporting the seat.
GB19