Peaq PDP 170 Bedienungsanleitung Seite 28

ENGLISH
• Refer all servicing to authorised service
agent. Do not attempt to repair the
product yourself. Servicing is required
when the product has been damaged
in any way, such as the supply cord or
plug are damaged, liquid has been spilled,
objects have fallen into the product, the
enclosure is damaged, the product
has been exposed to rain or moisture,
does not operate normally, or has been
dropped.
• Before connecting the product to a socket
outlet, make sure the voltage indicated
on the product corresponds to your local
mains.
• If the supply cord is damaged, it must
be replaced by the manufacturer or its
service agent or similarly qualified person
in order to avoid hazard.
• Regularly check if the supply cord, product
or extension cable is defective. If found
defective, do not put the product into
operation. Immediately pull the plug.
• Place the supply cord and, if necessary,
an appropriate extension cable in such
away that pulling or tripping over it is
impossible. Do not allow the supply cord
to hang down within easy reach.
• Do not jam, bend or pull the supply cord
over sharp edges.
• Only use the provided adaptor.
• The adaptor power plug is used as
the disconnect device; the disconnect
device shall remain readily operable. To
completely disconnect the power input,
disconnect the adaptor power plug.
• The product may not function properly or
not react to the operation of any control
due to electrostatic discharge. Switch off
and disconnect the appliance; reconnect
after a few seconds.
• Protect the supply cord from being walked
on or pinched particularly at the plug,
convenience receptacles and the point
where it exits from the product.
28
IM_PDP170_150518_V05_HR.indb 28
• Never pull the adaptor power plug by the
supply cord or with wet hands.
• Disconnect the adaptor power plug in
case of faults during use, during lightening
storms, before cleaning and when not
using the product for a longer period
of time.
• Danger! Before cleaning, switch the
product off and disconnect the adaptor
power plug from the socket.
• When the product has reached the end
of its service life, make it defective by
disconnecting the adaptor power plug
from the socket and cutting the cord
in two.
• Caution! There is danger of explosion
from improper replacement of the battery.
Replace battery only with the same or
equivalent type of battery.
• Always exchange the entire set of
batteries.
• Make sure the battery are correctly
inserted. Observe the polarity (+) plus / (-)
negative on the battery and the housing.
Improperly inserted battery can lead to
leakage or, in extreme cases, a fire or
an explosion.
• Never expose batteries to excessive heat
(e.g. bright sun, fire), and never throw
them into fire. The batteries could explode.
• The connections must not be short-
circuited.
• Remove used batteries. Remove the
batteries if you know that the product will
not be used for a longer period of time.
Otherwise, the batteries could leak and
cause damage.
• Keep batteries out of reach of small
children. If batteries have been swallowed,
seek immediate medical attention.
• Non-rechargeable batteries must not be
recharged.
• Remove the batteries from the product
before disposal.
18/5/15 11:29 AM