Connecting The Power Terminal - Pioneer PRS-A500 Bedienungsanleitung

Connecting the Unit

Connecting the Power Terminal

• Always use the special red battery and ground
wire [RD-223], which is sold separately. Connect
the battery wire directly to the car battery positive
terminal (+) and the ground wire to the car body.
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making all other connections to the
amplifier, connect the battery wire terminal
of the amplifier to the positive (+) terminal of
the battery.
Fuse (30 A)
Fuse (30 A)
Positive terminal
Insert the O-ring rubber
grommet into the vehicle
body.
2. Twist the battery wire, ground wire
and system remote control wire.
3. Attach lugs to wire ends. Lugs not
supplied.
• Use pliers, etc., to crimp lugs to wires.
Lug
Battery wire
7
Engine
Interior of
compart-
the vehicle
ment
Drill a 14 mm
hole into the
vehicle body.
Twist
Lug
Ground wire
4. Connect the wires to the terminal.
• Fix the wires securely with the terminal
screws.
GND terminal
Power terminal
Battery wire
WARNING
Failure to securely fasten the battery wire to the ter-
minal using the terminal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor burns.
System remote
control terminal
System remote
control wire
Ground wire