Pump Filter - Haier HW100-B14266A Handbuch

Care and cleaning
Pump filter
Please clean the filter once a month and check the pump
filter for instanvce if the appliance
▶
doesn´t drain the water.
▶
doesn´t spin.
▶
cause unusual noise while running.
Warning!
Scalding Risk! Water in the pump filter can be very hot! Before any
action please ensure water has cooled down.
1. Turn off and unplug the machine.
2. Open service flap. You can either use a coin or a
screwdriver.
3. Provide a flat container to catch leach water.
There could be bigger amounts!
4. Pull the drainhose out and hold its end above the
container.
5. Take the sealing plug out of the drainhose.
6. After complete drainage, unscrew and remove counter
clockwise the pump filter.
7. Remove contaminants and dirt.
8. Clean carefully pump filter, e.g. using running water.
9. Refix it thoroughly.
10. Close drainhose and push it back into the machine.
11. Close service flap
Caution!
Pump filter sealing has to be clean and unhurt.
If the lid is not full tightened, water can escape.
The filter must be in place, or it may lead to leakage.
19