Care And Storage - Beurer FB 50 Gebrauchsanleitung

once the set time has expired. Maximum duration is 60 minutes. Allow the footbath to cool for at least 15
minutes before using it again.
Temperature
The display shows the current water temperature. To change the temperature press and hold the tempera-
ture button (5) until you have set the desired water temperature (35, 38, 42, 45, 48 °C). The most pleasant
temperature is in the range 35 – 42 °C, the maximum temperature is 48 °C.
The temperature is factory-set to 35 °C.
Magnetic field and infrared
The footbath has four magnets and eight infrared lights integrated into the bath. They promote your circula-
tion and stimulate the reflex zones.
Massage roller
You can experience a special massage effect by moving your feet back and forth on the six massage rollers
integrated into the bottom of the footbath. The massage rollers can optionally be removed by pulling them
firmly upwards.
Removable attachments
Place the desired attachment on the holder in the centre. Press the attachment lightly down with your foot
to activate the electric motor.
The brush attachment can be used to stimulate the reflex zones in the soles of your feet
The massage attachment provides a soothing massage for your feet and promotes the circulation.
The corn and callus remover is used to remove dead skin cells and calluses.
The electric motor is protected from overheating and has a maximum load capacity. The motor stops if it is
overloaded or overheated. It can be used again after cooling down.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of the
body. However, we recommend studying relevant literature and asking your doctor before using
point reflex zone massage to achieve the desired effect.
• The footbath can also be used without water.
After use pour the water out over the narrow side (11) of the footbath. Do not allow water to come into
contact with the display.

6. Care and storage

After use rinse the unit with tap water. The foot bath can be cleaned with a mild, non-foaming household
cleaner, e.g. neutral vinegar. To dry the air lines, switch to the bubble setting without water for approx. 1
minute.
Note
• Do not allow water to penetrate the interior of the footbath.
• Store the footbath in its original packaging in a dry area.
• Do not leave it open for an extended period.
7. Disposal
Follow local regulations regarding the disposal of materials. The appliance should be disposed of
according to Regulation 2002/96/EC-WEEE (Waste Electrical and Electronic Equipment). In case of
queries, contact the municipal authorities responsible for waste disposal in your area
12