Closing And Saving Data; Technical Specifications - axing SZU 21-00 Betriebsanleitung

Operation Instructions SZU 21-00
Chapter 5: Technical specifications
Fig. 23: Saving satellite and
transponder lists to a file
5

Technical specifications

Tab. 1: Data sheet
09.08.16
Defining the default transponder
Sorting the transponders
Deleting a transponder
4.4.4

Closing and saving data

Click in the upper right corner to close the program.
Before the software closes, you will be asked whether you want to save the changes and a so-called
romimageSatfinder.bin file to be created.
Confirm by pressing Yes. This will save the romimageSatfinder.bin file to the smg folder. This file
contains the new satellite and transponder lists.
Transfer this file to the SAT-Navi (see 4.4 on page 11).
Frequency range 950...2150 MHz
RF connecters F female
Operating voltage 13...19 VDC
Current consumption 300mA
© AXING AG • Reserving change in design and type - We cannot be held liable for printing errors
Select a transponder by means of arrow keys and
press F4 key.
A yellow marking will appear in the Default column of
the transponder.
You can define only one transponder as the default
transponder.
Press F6 key
∂ You can sort according to frequency or polarization.
Select a transponder by using arrow keys and press
Delete key.
The transponders are marked for deletion with a red
cross.
Press Enter key to confirm
Press Delete key to cancel the deletion
15