Power Supply; External Power Supply; Satellite Receiver; Internal Batteries - axing SZU 21-00 Betriebsanleitung

Operation Instructions SZU 21-00
Chapter 2: Power supply
2

Power supply

Fig. 4:DC-power supply socket
(1),slide switch (2)
6
There are three ways to establish the power supply of the device:
2.1.1

External power supply

∂ Connect the external power supply to the DC-power supply socket (1).
∂ Make sure the slide switch (2) is in the position ("EXT").
2.1.2

Satellite receiver

∂ The SAT-Navi can be operated by delivering the power remotely from a satellite receiver or
multiswitch (which may be supposed to be connected to the LNB after searching the Satellite).
∂ The receiver/multiswitch should be able to deliver 600mA of current to the LNB!
∂ Make sure the power supply selector is in the position ("EXT").
∂ Connect the LNB/IF input of the satellite receiver to the DC power supply input (8) of the SAT-Navi
∂ If the SAT-Navi does not power up or switches off when trying to search satellites, the current
delivered by the receiver may be insufficient. Please use another receiver or another way of supply.
2.1.3

Internal batteries

∂ Make sure, you have inserted fitting batteries into the compartment in the right direction.
∂ Put the Power Supply Selector in the lower position ("BATT") to activate battery operation.
∂ You can use non-rechargeable and rechargeable batteries in AA size.
Low Voltage
∂ If the voltage of any power source is lower than 13.3V, the red low voltage LED lights up
∂ Take care, that the input voltage is always higher than 13.3V.
∂ If you are using rechargeable batteries, switch off (to "EXT") the device when the red LED lights up to
prevent the cells from total discharge.
© AXING AG • Reserving change in design and type - We cannot be held liable for printing errors 2016-08-09