Light Menu; Update; Connecting The Sat-Navi To The Pc - axing SZU 21-00 Betriebsanleitung

Operation Instructions SZU 21-00
Chapter 4: Update
Fig. 13: Selecting an LNB
Note
4

Update

Fig. 14: RS-232 adapter
09.08.16
In the main menu, use button 4 to select the menu item DiSEqC 1.0 and press OK to confirm.
In the DiSEqC 1.0 menu, activate the desired LNB (LNB A to LNB D) by pressing buttons 4 and 5.
Return to the main menu by pressing the OK button.
Then select a satellite and start search via the SAT-Navi menu.
After switching off the SZU 21-00, the DiSEqC control is deactivated again.
3.4

Light menu

In the Light Menu, you can switch the background light of the LCD on or off.
For always being up to date, a software update of the SAT-Navi can be carried out via the serial RS-232
interface. Since most modern PCs don't have an RS-232 port any more, a USB adapter has to be used. It
is included in the programming set SZU 22-00 (the programming set must be ordered separately).
4.1

Connecting the SAT-Navi to the PC

To update the software, the following steps are required:
4. Connect the adapter to the update port of the SAT-Navi located in the battery compartment.
RS-232
adapter
5. Connect the update adapter to the USB adapter via a null modem cable.
© AXING AG • Reserving change in design and type - We cannot be held liable for printing errors
...
9