Cleaning; Installation - Pelgrim DOCK 30 domino Anleitung

Cleaning

Disconnect gas and electricity!
Hot soapy water
■ In principle the appliance can be cleaned
with hot soapy water. Always use a soft
cloth and rinse well with clean water.
Liquid cleaners
■
For all enamelled parts such as the pan
supports and the burner lids. Soak badly
stained parts first.
Brillo pads
■ Use only for badly stained enamelled parts.
Glassex/window cleaner
■ For the synthetic parts such as the knobs.
Stahlfix
■ Cover and splash tray.
What you should not use
■ Scouring or aggressive cleaning agents,
such as grill and oven sprays, stain and
rust removers, scouring sand etc.
Damage due to foods with a high
sugar content
This can be largely prevented by regularly
treating the hob with Atag Shine cleaning
agent. This cleaning agent forms a layer of
silicone film on the hob surface. However, this
silicone film will not be resistant to the
extreme temperatures of the zones for very
long and must therefore be reapplied
frequently.
Scratches
■ The hob surface can become scratched
when grains of sand are drawn across the
hob with the pan (when cleaning
vegetables, for example).
Sharp edges on the bases of pans
■ These will scratch if they are slid across
the hob surface, be especially careful with
cast iron pans.
Anything that can melt
■ Plastics, aluminium foil, but especially
foods with a high sugar content should be
kept well away from the hot hob.
If anything should melt, remove it
immediately with the scraper to avoid
permanent damage.
Installation of the gashob
The installation and gas connection must be
carried out by a registered CORGI-Gasfitter.
It must be made in accordance with the
official national and local regulations. Also the
electrical installation must be in accordance
with all regulations.
Warning
Because this cooking-appliance is not
connected to a flue duct, special attention has
to be taken in view of ventilation of the
kitchen.
Gas and gas pressure
The kind of gas and the gas pressure must be
in accordance with the data on the data-
badge. In the factory the appliance has been
built to work on natural gas.
Gas connection
The gas connection of this appliance is G1/2"
external in the gas supply of the hob must be
fitted an isolation tap, that is placed on an
easily attainable place, e.g. in an adjacent
cabinet. If the appliance is connected with a
special safety gauge, take care that this
gauge is not in contact with hot parts.
Check after the connection of the hob, if the
burners function well and if they do not
extinguish in minimum position of the knobs.
Installation of the other domino
appliances
The other DOMINO appliances are electrical
appliances and must be connected in
accordance with the national and local
regulations.
Placement
Because of fire hazard, the distances between
DOMINO appliances and combustible walls -
think of high cupboards for instance - should
be at least 5 cm.
Caution! For the barbecue this distance
should be at least 12 cm. The distance
between an appliance and a cooker-hood
placed above it should be at least 60 cm (see
fig. 14).
min. 50
min. 15
min.600
min. 50 min.50 fig. 14
Measures of DOMINO appliances
The measures and the built-in dimensions of
the DOMINO appliances are indicated in
fig. 15, while in fig. 16 and 17 you can see how
the appliances are fixated in worktops of
various thicknesses by means of clamps.