Rs-232C Command Table - Sharp PN-525E Bedienungsanleitung

Controlling the Monitor with a PC

RS-232C command table

How to read the command table
Command: Command field (See page 24.)
Direction: W When the "Parameter" is set in the parameter field (see page 24), the command functions as described
R The returned value indicated under "Reply" can be obtained by setting "????", "
Parameter: Parameter field (See page 24.)
Reply: Response (Returned value)
*: "Yes" indicates commands which can be used in power standby mode.
TIPS
• To specify the horizontal/vertical positions for vertical orientation, specify the values for horizontal orientation.
Power control/Input mode selection
Function
POWER CONTROL
INPUT MODE SELECTION
SCREEN menu (PC2/PC3)
Function
AUTO
CLOCK
PHASE
POSITIONING POSITION OF
THE LONGEST
DIRECTION
POSITION OF
THE SHORTEST
DIRECTION
RESET
28
E
under "Control/Response Contents".
(repeater control) in the parameter field (see page 24).
Command Direction Parameter
POWR W
R
INPS W
R
Command Direction Parameter
ASNC W
CLCK WR
PHSE WR
HPOS WR
VPOS WR
ARST W
Reply
0 Switches to standby mode.
1 Returns from standby mode.
0 Standby mode
1 Normal mode
2 Input signal waiting mode
0 Toggle change for input mode
Terminals not selected in DVI SELECT/BNC SELECT cannot be
selected.
1 PC1 DIGITAL
"ERR" when AV (DIGITAL) is selected for DVI SELECT.
2 PC2 ANALOG
3 AV2 COMPONENT
"ERR" when PC (ANALOG) is selected for BNC SELECT.
4 AV3 VIDEO
6 PC3 ANALOG
"ERR" when AV (COMPONENT) is selected for BNC SELECT.
7 AV1 DIGITAL
"ERR" when PC (DIGITAL) is selected for DVI SELECT.
1 PC1 DIGITAL
2 PC2 ANALOG
3 AV2 COMPONENT
4 AV3 VIDEO
6 PC3 ANALOG
7 AV1 DIGITAL
Reply
1
0-255 0-255
0-63 0-63
0-500 0-500 A maximum value depends on a resolution.
0-100 0-100
1
?" or "???+"
Control/Response contents
Control/Response contents
*
Yes
Yes
*
No
No
No