Herunterladen Inhalt Inhalt Diese Seite drucken

Uppackning Och Montering; Charging Station - Electrolux ergorapido zb 2820 Handbuch

Inhaltsverzeichnis

Werbung

20
19
21
22a
22
Centaur_27lang_Rev8_081007.indd 8
Svenska

Uppackning och montering

Kontrollera att samtliga delar finns i kartongen.
19. Sätt försiktigt fast handtaget i dammsugarkroppens
nedre del. Se till att sladden inte fastnar.
20. Säkra skaftet genom att skruva i den medföljande
låsskruven.
Använd en skruvmejsel eller ett mynt.
Laddstation
21. Placera laddstationen nära ett eluttag på säkert
avstånd från värmekällor och väta. Sätt i adaptern i
eluttaget och anslut den till laddstationen. Undertill
på laddstationen finns en urtagning där överflödig
sladdlängd kan lindas in (21a).
22. Väggenheten kan monteras på en vägg (22a). Lossa
väggenheten från golvenheten (22b). Se till att
väggen klarar dammsugarens vikt.
21a
22b
English
Unpacking and assembly
Check that all parts are in the box.
19. Fit the handle by carefully inserting it into the lower
main body. Make sure that the cable does not jam.
20. Secure the handle by tightening the locking screw
supplied.
Use a screwdriver or a coin.

Charging station

21. Position the charging station close to a mains socket
(well away from heat sources or wet places). Insert
the adaptor into the mains socket and connect it to
the charging station. Underneath the charging station
there is a hollow space where redundant cable can
be wound (21a).
22. The wall unit can also be mounted on a wall (22a).
Release the wall unit from the floor unit (22b).
Always ensure that the wall can bear the weight of
Ergorapido.
8
2008-10-10 16:06:43

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis