Setting The Speaker Levels; Adjusting The Volume During Playback; Using The Test Tone - Yamaha HTR-5630RDS Bedienungsanleitung

Adjusting the volume during
playback
You can adjust the volume of the speakers while listening
to sound playback.
PROG
LEVEL
1
2
1
Press LEVEL repeatedly to select the
speaker you want to adjust.
The unit cycles through the speakers in the following
order each time you press LEVEL:
MAIN L→CENTER→MAIN R→
R SUR. (rear R)→L SUR. (rear L)→
SWFR (subwoofer)→.....
y
• Pressing LEVEL once opens the level display. Press u / d at
this time to select a speaker.
2
Press –/+ to adjust the speaker volume.
• The center and rear speakers can be adjusted by a
maximum of –10dB ~ +10dB.
• The main speakers and subwoofer can be adjusted
by a maximum of –20dB ~ 0dB.
Notes
• You cannot adjust speaker levels if the "SOUND 1 SPEAKER
SET" parameter in the set menu is set to NON.
• You cannot adjust the subwoofer level if the "1D BASS"
parameter in "SOUND 1 SPEAKER SET" in the set menu is
set to MAIN.
• If you use LEVEL to adjust speaker levels, the speaker levels
you previously set with the test tone will also change.
• If you select "BASIC 1 SETUP" in the set menu and then
select "SET", speaker levels change in response to any
changes you make in "BASIC 1 SETUP".

SETTING THE SPEAKER LEVELS

PROG
MUTE
SET MENU
VOLUME

Using the test tone

Use the test tone to set speaker levels so that the volume
from each speaker is identical when heard from your
listening position.
TEST
1,4
PROG
LEVEL
2
1
Press TEST.
The unit will output a test tone.
2
Press u / d repeatedly to select a speaker
to adjust.
Each time you press d, the unit will cycle through
the speakers in the following order:
TEST LEFT (main L)→TEST CENTER (center)→
TEST RIGHT (main R)→TEST R SUR. (rear R)→
TEST L SUR. (rear L)→TEST SUBWOOFER
(subwoofer)→.....
(Press u to cycle the speakers in the reverse order.)
3
Press –/+ to adjust speaker volumes.
4
Press TEST when you have completed your
adjustment.
The test tone halts.
Notes
• You cannot enter test mode if headphones are connected to the
PHONES jack. Remove the headphones from the PHONES
jack.
• You cannot adjust speaker volumes if the "SOUND 1
SPEAKER SET" parameter on the set menu is set to NON.
• You cannot adjust the subwoofer level if the "1D BASS"
parameter in "SOUND 1 SPEAKER SET" in the set menu is
set to MAIN.
• If you select "BASIC 1 SETUP" in the set menu and then
select "SET", speaker levels change in response to any
changes you make in "BASIC 1 SETUP".
y
• Depending on the source the unit is reproducing, the speaker
levels set with the test tone may not be to your liking. If this is
the case, adjust the speaker levels while listening to the
source.
STEREO
VOLUME
PROG
MUTE
SET MENU
VOLUME
3
45