Herunterladen Inhalt Inhalt Diese Seite drucken

Using Other Subwoofer; Connecting Antennas - Pioneer X-HM51-K Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 74
Connections
If not using the provided speaker wire
1
Twist exposed wire strands together.
2
Loosen terminal and insert exposed wire.
3
Tighten terminal.
1
2
10 mm
X-HM51 only
• Do not install your speakers overhead on the ceiling or wall.
The grill is designed to be detachable, and as such it may
fall and cause damage or personal injury if installed
overhead.
• Do not allow any objects to fall into or to be placed in the
bass reflex ducts.
• Do not stand or sit on the speakers. You may be injured.

Using other subwoofer

You can connect a subwoofer with an amplifier to the
SUBWOOFER PREOUT socket.
This unit's rear panel
SUBWOOFER
LINE
PREOUT
IN
Audio cable
(commercially available)
Commercially available
subwoofer (amplifier built in)
Note
• No sound is heard from the subwoofer without a built-in
amplifier.
• Subwoofer Pre-out (audio signal): 350 mV / 10 k
Hz.
3
ANTENNA
AM
LOOP
R
FM
UNBAL
75 Ω
L
To audio input
socket
at 70

Connecting antennas

Connect the AM loop antenna and the FM wire antenna as
shown below. To improve reception and sound quality,
connect external antennas (see Using external antennas on
page 12).
fig. a
ANTENNA
AM
4
LOOP
FM
UNBAL
75 Ω
1
Connect the AM antenna wires.
Hold the terminal part of the wire when connecting.
2
Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the direction indicated
by the arrow (fig. a) then clip the loop onto the stand (fig. b).
3
Place the AM antenna on a flat surface and
in a direction giving the best reception.
4
Connect the FM wire antenna into the FM
antenna socket.
For best results, extend the FM antenna fully and fix to a wall
or door frame. Don't drape loosely or leave coiled up.
To customers in Norway and Sweden
CAUTION
• "Apparater som er koplet til beskyttelsesjord via
nettplugg og/eller via annet jordtilkoplet utstyr - og er
tilkoplet et koaksialbasert kabel-TV nett, kan forårsake
brannfare. For å unngå dette skal det ved tilkopling av
apparater til kabel-TV nett installeres en galvanisk
isolator mellom apparatet og kabel-TV nettet."
• "Apparater som är kopplade till skyddsjord via jordat
vägguttag och/eller via annan utrustning och samtidigt
är kopplad till kabel-TV nät kan i vissa fall medföra risk för
brand. För att undvika detta skall vid anslutning av
apparaten till kabel-TV nät galvanisk isolator finnas
mellan apparaten och kabel-TV nätet.
03
fig. b
2
1
3
11
En

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

X-hm51-sXc-hm51-kXc-hm51-s

Inhaltsverzeichnis