Remote Control; Connecting To Power; Power Supply - Roadstar HIF-1800TUMPK Bedienungsanleitung

30) RANDOM INDICATOR
31) PROGRAM INDICATOR
32) CD STOP BUTTON
33) TAPE FF/EJECT BUTTON
34) TAPE SLOT-IN
35) TOP COVER MECHANISM
36) TURNTABLE

REMOTE CONTROL

BATTERY INSTALLATION
the infra-red transmitter requires 2 pcs CR-2025 size battery for operation.
37) OPEN / CLOSE CD DOOR.
38) RECin cd or phono mode, press to active
recording function.
39) REPEAT BUTTON
40) PLAY/PAUSE in CD/USB mode, press
once to start playback. press again to enter pause
mode.
41) skip/search backward press once to skip
to previous tack.press & hold for search
backward.
42) SKIP/SEARCH forward press once to skip
to next track, press & hold for search forward.
43) STOP in CD/USB mode, press to stop playback or cancel the stored program.
44) + 10 Track Button
45) - 10 Track Button
46) RANDOM BUTTON in CD/USB mode, press to active random function.
47) DELETE button
48) PROGRAM in CD/USB mode, press to active programming function.
English
3
38
37
39
40
41
42
43
44
45
46
47
48
English
4

CONNECTING TO POWER

Before switching on make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect this
unit to the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other power
sources may damage the unit.
CAUTION
To prevent electric shock disconnect from the mains before removing cover. No user serviceable
parts inside. Refer servicing to qualified service personnel.
SAFETY PRECAUTION
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: 230V 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not required.

POWER SUPPLY

Remove the stereo carefully from the box, retaining the packaging for future use.
AC POWER OPERATION
Connect the plug to a mains power inlet 230V AC ~ 50 Hz.
MW/FM TUNER
Operation
• Press the Power button (15).
Select the desired frequency band with the Function Selector
•
• Tune to the desired radio station by turning the Tuning control (21).
ANTENNA
• For FM reception there is a built-in FM antenna wire (28) at the rear of the unit. Move the wire
around to obtain the best reception.
• For MW reception the signals are picked up through a built-in ferrite antenna. Your may have
to orient the unit to obtain the best reception.
(6) for FM or MW band.