Symbols On The Control Panel; Avoiding Fire Hazards With Built-In Appliances; Installation Accessories; Installation Instructions - BOMANN MWG 2215 EB Bedienungsanleitung

Symbols on the control panel

Meaning/
Symbol
function
Microwave
Defrosting
Grill
Microwave + grill
Power high/low

Avoiding Fire Hazards with Built-in Appliances

Always observe the instructions contained in the section "Installa-
tion Instructions".
• Do not remove the feet on the underside of the device.
• Use only the mounting materials supplied for the installation.
• When installing the microwave oven, please adhere to the
dimensions shown in drawings 1 and 2.
• The rear wall of the cupboard has to be removed!
• There is a ventilation slot at the bottom edge of the mounting
frame. Keep the ventilation slots free at all times.

Installation Accessories

Item
A
B
C
D

Installation Instructions

This microwave oven must be installed in a tall or wall cupboard.
Please note the following instructions:
• Remove everything that is fragile from the adjacent cup-
boards.
• For installation the cabinet must meet the following condi-
tions:
• The cupboard must not contain any cracks, splinters or
other damage. All connections must be stable.
• The cupboard must be designed for a minimum load of
40 kg.
• The microwave oven must be installed at a height of at
least 85 cm.
• The rear wall of the cupboard has to be removed so that
the microwave oven is ventilated!
• The thickness of the cupboard wall must be at least
19 mm.
20
Meaning/
Symbol
function
Child-proof lock
activated
Auto function
Weight in grams
Programmed
Start
Designation Number
Adjustment screw 1
Mounting frame 1
Screw 1
Dummy plug 1
• Wall cupboards must be anchored firmly in the wall with
at least 2 screws. Check the stability by attaching an ap-
propriate weigh.
• In the case of wall cupboards the installation depth of the
cupboard has to be at least 320 mm.
CAUTION:
Do not install the device above a cooker!
• When installing the device it must be ensured that there is a
power socket within reach.
• The mains socket must be within easy reach, so that the plug
can be quickly removed in an emergency.
• Important! Do not connect the device to the mains power
supply until after installation!
WARNING:
• Please adhere to the dimensions stated in the installation
instructions.
• The installation accessories supplied should be used.
• If screws are inserted too deeply (screws too long) this may
damage the device or represent a hazard to the user or oth-
ers.
Dimensions of the Built-in Cupboard
Make a built-in cupboard or a niche in accordance with the follow-
ing dimensional drawings. Figure 1 is for wall cupboards, figure 2
for tall cupboards.
Installation (Figures 3 to 6)
• Screw the adjustment screw (A) completely into the upper air
duct (E).
• Put the microwave in the built-in cupboard.
• Now unscrew the adjustment screw until it is about 1 mm
below the top of the cupboard.
NOTE:
This prevents the microwave oven from tilting over in the
cupboard.
• Push the microwave completely into the cupboard and pull
the connection cables in after it.
• Align the microwave with the centre of the cupboard.
• Secure the microwave with the screw (C) and seal the open-
ing with the dummy plug (D).