Wacom DTF-521 Benutzerhandbuch Seite 41

Double-clicking is difficult.
You notice a delay at the
beginning of pen strokes.
You have to press hard with
the pen when clicking,
drawing, or writing.
The pen tip does not
function.
The side switch does not
work.
Be sure you are quickly tapping the display screen twice in the same
place on the pen display tablet's active area. Wacom recommends
using the side switch to double-click.
Open the Pen Tablet control panel and go to the P
increasing the D
OUBLE
Windows: Try setting your system to launch programs with a single
click. See Pen operations on page 18.
Open the Pen Tablet control panel and go to the P
decreasing the D
OUBLE
Open the Pen Tablet control panel and go to the P
T F slider toward S
IP EEL
Be sure you are using the pen that originally came with your pen
display. Other pens may not function properly on the DTF-521 pen
display.
Make sure the status LED lights blue when the tip is pressed. If the
LED does not light, verify that the USB cable is plugged into an active
port on your computer or on a USB hub.
If the LED still does not light, you may have defective hardware
(see Troubleshooting on page 32).
Be sure you are using the pen that originally came with your pen
display. Other pens may not function properly on the DTF-521 pen
display.
Be sure you press the side switch when the pen tip is within 5 mm
(0.2 inch) of the pen display's active area – do this without pressing
down on the pen tip.
From the Pen Tablet control panel, verify that the side switch is set to
the proper function you are expecting to occur.
Make sure the status LED lights blue when you press the side switch.
If the LED does not light, verify that the USB cable is plugged into an
active USB port on your computer or on a USB hub; the LED will not
light if the USB cable is not plugged into an active port.
If the LED does not light, you may have defective hardware
(see Troubleshooting on page 32).
C D or using a lighter T
LICK ISTANCE
C D .
LICK ISTANCE
.
OFT
tab. Try
EN
F .
IP EEL
tab. Try
EN
tab. Move the
EN
Troubleshooting
Page 37