Calibrating The Dtf-521 - Wacom DTF-521 Benutzerhandbuch

CALIBRATING THE DTF-521

You must calibrate the pen display tablet in order to align the screen cursor position with the position of
the pen on the display screen. This is required to adjust for parallax caused by the display screen cover
glass and coating. Set the DTF-521 in its working position, then follow the procedure below.
Important: Make sure the display is properly
adjusted before calibrating the tablet.
See Adjusting pitch and phase on page 30, and
Adjusting the display beginning on page 27.
• In the Pen Tablet control panel, select the
C tab.
ALIBRATE
• If you are working with multiple monitors, select
the M corresponding to the DTF-521
ONITOR
display. (Only monitors that are set to one of the
resolutions supported by the DTF-521 will appear
in the list.)
• Click on the C
ALIBRATE
calibration screen.
• Hold the pen and position your head as you
normally do when working with the pen display.
Use the pen tip to click on the center of the
crosshairs in the upper-left corner.
• Then click on the center of the crosshairs that are
displayed in the lower-right corner.
• Test the alignment by positioning the pen at a few
different points on the display. Click OK to accept
the calibration. Click T
Be sure to read the directions in the calibration
screen for detailed instructions and additional
options. The calibration setting applies to all
applications.
Adjustment pattern for pitch and phase.
See Adjusting pitch and phase on
page 30 for details.
Notes:
If you prefer to see the screen cursor slightly
offset from the actual position of the pen tip,
calibrate by clicking on a spot showing that offset from the crosshairs. For example, to have the screen
cursor appear 1/10th of an inch above and to the left of the pen tip, calibrate by clicking on a spot 1/10th of
an inch below and to the right of the crosshairs.
To calibrate two pen displays, first touch the pen to pen display #1 and open the control panel without
touching the pen to pen display #2. In the control panel, select the correct monitor and calibrate pen display
#1. Close the control panel, touch the pen to pen display #2, and again open the control panel without
touching the pen to pen display #1. Select the correct monitor and calibrate pen display #2.
Customizing
Page 22
... button to activate the
A to recalibrate.
RY GAIN
Crosshairs