Step 1: Lcd Monitor Installation - Wacom DTF-521 Benutzerhandbuch

STEP 1: LCD MONITOR INSTALLATION

In the first stage of the installation process, the DTF-521 is installed as a monitor on your system. As
you work through the first stage of the installation process, please refer to the LCD monitor cabling
diagram on the following page when making cable connections.
Important: Do not connect the USB data cable until instructed to do so.
•
Turn off your computer.
Caution: Never connect or disconnect the video or power cables while your computer or DTF-521
are powered on – this can damage the display or video card.
•
If your computer has only one analog (VGA) video connector, you will need to unplug your previous
monitor or add a second VGA card.
•
Plug one end of the VGA cable into the DTF-521. Plug the other end of
the cable into the VGA connector on your computer's video card. See –
A – in the connection diagram on page 12. Be sure to tighten the
thumbscrews on the connectors.
•
Connect the power adapter to the DTF-521. Then connect the adapter's power cable and plug the
adapter into an AC outlet. See – B – and – C –
•
Turn on the DTF-521. The power LED will light orange.
VGA connector
Installation
Page 11