Installing/Removing Main Memory - Fujitsu D3441 Kurzanleitung

Installing/removing main memory

Installing/removing main memory
Technical data
Technology
Total size
Module size
A current list of the memory modules recommended for this mainboard is available
on the Internet at: "http://www.fujitsu.com/fts/products".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
For D3441-S, D3445-S and D3445-K, only unbuffered DDR4 memory
modules without ECC may be used.
DDR4 memory modules must comply with the DDR4-1866 or DDR4-2133 specification.
DDR4-2133 modules are downward compatible and are operated depending on the CPU.
If you use more than one memory module, then make sure to distribute the
memory modules over both memory channels. By doing this you use the
performance advantages of the dual-channel mode.
Maximum system performance is achieved when identical memory modules
are used in Channel A and Channel B.
To simplify equipping, the slots are colour coded.
Depending on how the system is configured, the visible main memory can be reduced.
Channel B, Slot 2
Channel B, Slot 4
Channel A, Slot 1
Channel A, Slot 3
Slot to be used
Channel A, slot 1
Channel B, slot 2
Channel A, slot 3
Channel B, Slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
Fujitsu
DDR4 1866/ 2133 MHz unbuffered DIMM/SO-DIMM modules 260 pin;
1.2V; 64-bit no ECC, D3446-S with ECC
1 to 32 GB DDR4 (up to 64 GB on D3446-S)
1, 2, 4, 8 or 16 GB per module
Number of memory modules inserted
1
x
2 3
x x
x x
x
English - 7
4
x
x
x
x
21