Kathrein HDP 600 Montageanleitung Seite 10

Note: If the "Antenna confi guration" setting is selected, it is essential to select "CAP" for the "System"
parameter (see CAP 600 installation and operating instructions, page 48)!

7. Use the buttons to select the Elevation option and use the number keys on the remote control to
enter "400"

button and the turntable will move to the selected elevation angle.
8. Press the
9. Switch off the UFS 740 at the main switch on the front, and disconnect it from the power.
10. Now install the BAS 60, (observing the required
polarisation setting - see "Polarisation setting"
in the CAP 600 installation and operating
instructions) on to the HDP 600, using the two
screws supplied (see diagram on the right)
Make sure that the Sat-IF cable for the HDP
600 runs in the recess provided for it on the
HDP 600 and the LNB housing at the rear of the
antenna, so that it is protected from damage.
Tighten the cap screws to a torque of 6-7 Nm.
11. Now connect the Sat-IF cable on the HDP 600 to
the LNB input on the BAS 60
12. If you have not already done so, secure the Sat-IF
cable on the HDP 600 in the cable bracket on the
LNB housing
#
13. Use the fl at-head screws supplied to secure the LNB protective cover back on to the antenna
(do not use the old knurled screws, because otherwise a collision will occur between the antenna
and the automatic position!!)
14. Leave the installation location and reconnect the UFS 740sw to the power supply
15. Switch the receiver on fi rstly with the main switch and then with any of the numeric buttons
16. You will then see the message "Please wait, initialising HDP". Wait until the message "Position of Astra
is not known. Start search?" is displayed – then abort this procedure using the
17. Next, press the
"Settings" menu item. Confi rm the selection by pressing the
to move to the "Antenna Confi guration" menu item. Confi rm the selection by pressing the

18. Use the buttons to move to the menu item "Reset the motorised antenna". Confi rm the selection

by pressing the

by pressing the
19. Now continue with the actions described in chapter "CAP 600 operating instructions" of the CAP 600
installation and operating instructions.
10
INSTALLATION

button to go to the main menu and use the
button. Once the antenna has been reset, you can return to the normal TV picture
button.
Sleeve

button.

buttons to move to the

button. Use the
6-7 Nm

buttons

button.