Danger Of Fire; Master/Slave-Operation; Operation; Sound-Control/Master/Slave-Operation - EuroLite BS-40 Bedienungsanleitung

Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Mount the device to your trussing system using an appropriate clamp.
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the attachment eyelet
on the rear panel of the device and over the trussing system or a safe fixation spot. Insert the end in the
quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
In general, lighting effects should not be connected to dimming-packs.
Before taking into operation for the first time, the installation has to be approved by an expert!

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the BS-40 you can find three XLR-jacks (Out) and an XLR-plug (In), which can be used
for connecting the devices.
The master-device controls all other slave-devices, which are to be connected to the master-device via a
balanced microphone lead. Connect the OUT-jack with the IN-plug of the next device.

OPERATION

After you connected the effect to the mains, the BS-40 starts running.

Sound-control/Master/Slave-operation

The lamp is automatically ignited as soon as the condensor microphone receives music signals.
You can do without a controller as the BS-40 features a built-in microphone, which provides automatic sound
control.

DANGER OF FIRE!

International
L
N
DANGER TO LIFE!
17/35 51806240X84NXS_V_1_0.DOC