BOMANN GS 4262 Gefrierschrank Seite 16

located in the interior or on the rear side of the
appliance.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid Avoid Avoid the installation: Avoid the installation: the installation: the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION: CAUTION: CAUTION: CAUTION:
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening Reverse the door opening Reverse the door opening Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING: WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE NOTE NOTE: : : : NOTE
• When installing, ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Remove the hinge cover (1). Loosen
the screws underneath (2) and re-
move the upper door hinge (3).
Open the appliance door a little and lift it out.
• Loosen the screw (1) and
remove the door stopper (2)
electric
electric electric
Attach the delivered door stopper to the opposite
door underside. Place the door safely aside.
NOTE: NOTE: NOTE: NOTE:
Keep the door stopper (2) for another possible
door stop reversibility.
• Move the blind covers to the opposite
holes.
• Tilt the appliance slightly backwards
and block it in this position. Unscrew
the feet and dismount the lower door
hinge.
• Attach the lower door hinge at the other appliance
underside and turn in the feet accordingly.
• Replace the appliance upright. Put on the appli-
ance door and fix it in its intended position.
• Transfer the upper door hinge at the opposite
appliance topside. Put the hinge pin in the hole of
the appliance door and fasten the hinge. Replace
the hinge cover.
16
screw wrench, Phillips screw-