Preparing For Use; Inserting / Replacing The Batteries - Silvercrest IAN 104412 Premium Wireless Doorbell Montageanleitung Und Bedienungsanleitung

Preparing for use

Inserting / replacing the batteries

Insert the batteries to provide power to the device before prepar-
ing it for use.
CAUTION! Use the indicated battery types only. Failure to ob-
serve this advice may result in damage to the product.
Receiver (see Fig. B):
Remove the battery compartment cover from the back of the
6
device.
Remove the used batteries, if present.
Insert 3 batteries (1.5 V , type AA).
Note: Ensure correct polarity. This is indicated in the battery
compartment .
8
Close the battery compartment .
8
Transmitter:
Remove the holder by pressing the lock from the back of
12 11
the transmitter and remove the rubber cover (see fig. C1).
15
Remove the used batteries, if present (see fig. C2).
Insert a battery (3 V , type CR 2032). The side marked "+"
must face upwards.
Install the rubber cover , close the holder of the transmitter
15 12
back on to the back of the device.
GB/IE 15