Wall-Mounting The Base; Connecting The Charger Cradle; Inserting The Batteries Into The Handset - Silvercrest SGKT 50 A1 Bedienungsanleitung

SilverCrest SGKT 50 A1

Wall-mounting the base

You can also mount the base on the wall. Proceed as follows:

Drill two holes with a vertical distance of 102 mm.

Insert suitable rawlplugs into the drilled holes.

Insert suitable screws into the rawlplugs and turn them in until they protrude approx. 5
mm from the wall.

Hang the base [B] on the screw heads and then pull it downwards until it becomes fixed.

Turn the telephone receiver fixing [30] on the base [D] 180° so you can mount the
telephone receiver.
When wall-mounted, if you wish to put the telephone receiver aside without ending a
phone conversation, you can place the receiver onto the telephone receiver holder [31]
on the base [B].

Connecting the Charger Cradle


Connect the charging cradle plug to a power socket using power adapter [C].

Inserting the Batteries into the Handset

Open the battery compartment by gently pressing the indentation of the battery compartment cover
and then sliding it downwards. Insert the rechargeable batteries into the handset [D] as illustrated
below. Take care to insert the batteries into the handset [D] observing the correct polarity
(+ and – ). The correct polarity is labelled on the batteries and inside the battery compartment.
Close the battery compartment with the cover.
(The figure is representational)
16 - English