Installation; Electrical Connection; Ventilation Requirements; Noises - AEG A61900HLW0 Benutzerhandbuch

32

Installation

INSTALLATION
Positioning
WARNING!
If you are discarding an old appliance that has a lock or catch on the lid, you must ensure
that it is made unusable to prevent young children being trapped inside.
The appliance shall have the plug accessible after installation.
This appliance can be installed in a dry, well ventilated indoor (garage or cellar), but for op-
timum performance install this appliance at a location where the ambient temperature cor-
responds to the climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate corre-
spond to your domestic power supply.
The appliance must be earthed. The power supply cable plug is provided with a contact for
this purpose. If the domestic power supply socket is not earthed, connect the appliance to a
separate earth in compliance with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Directives.

Ventilation requirements

1. Put the freezer in horizontal position on a firm surface. The cabinet must be on all four
feet.
2. Make sure that the clearance between the appliance and rear wall is 5 cm.
3. Make sure that the clearance between the appliance and the sides is 5 cm.
The airflow behind the appliance must be sufficient.

NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Ambient temperature