Replacing The Lamp; Closing The Door - AEG SKS61240S0 Benutzerinformation

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.

REPLACING THE LAMP

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
1. Disconnect the mains plug from the
2. Remove the screw from the lamp
3. Remove the lamp cover (refer to
4. Replace the used lamp with a new
5. Install the lamp cover.
6. Tighten the screw to the lamp cov-
7. Connect the mains plug to the
8. Open the door. Make sure that the
3. If necessary, replace the defective
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
mains socket.
cover.
the illustration).
lamp of the same power and spe-
cifically designed for household ap-
pliances. (the maximum power is
shown on the lamp cover).
er.
mains socket.
lamp comes on.
door gaskets. Contact the Service
Center.
ENGLISH
15