Zanussi ZWH 7140 AP Benutzerhandbuch Seite 9

Tie the plastic hose guide to the tap with a string to pre-
vent that the drain hose unhooks when the appliance is
emptying.
• O O nto a sink outlet spigot.
Push the drain hose onto the spigot and secure with a
clip, ensure a loop is formed in the drain hose to pre-
vent waste from the sink entering the appliance.
C C onnections overview
115
115 cm
c m
100 c m
If the outlet spigot has not been used before, remove
any blanking plug that may be in place.
• D D irectly into a drain pipe at a height of not less than
60 cm and not more than 100 cm.
• D D irectly to a built-in drain pipe in the room wall.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece
is available from your Local Centre.
140 cm
150
The end of the drain hose
must always be v v entilated,
i.e. the inside diameter of
the drain pipe must be
larger than the outside di-
ameter of the drain hose.
The drain hose must not
be kinked.
9 0 c m
c m
9 9