Philips 202P4 Benutzerhandbuch Seite 68

Regulatory Information
Energy Star Declaration
This monitor is equipped with a function for saving energy which supports the VESA Display Power
Management Signaling (DPMS) standard. This means that the monitor must be connected to a
computer which supports VESA DPMS to fulfill the requirements in the NUTEK specification
803299/94. Time settings are adjusted from the system unit by software.
NUTEK
Normal operation
Power Saving
Alternative2
One Step
A
s an
E
the
We recommend you switch off the monitor when it is not in use for quite a long time.
Federal Communications Commission (FCC) Notice (U.S. Only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
file:///D|/EDFU/crt_19_5/edoc/german/202P/SAFETY/regs/regulat.htm (7 of 15)2005-04-21 ¤W¤È 10:14:23
VESA State LED Indicator
ON Green
OFF Yellow
®
E S P
NERGY TAR artner,
®
S
NERGY TAR guidelines for energy efficiency.
RETURN TO TOP OF THE PAGE
PHILIPS
202P4*
Power Consumption
Typical 125 W
< 1W
PHILIPS
has determined that this product meets