Li-Ion Batteries - Charging / Balance-Charging; Fast-Charging / Storage-Automatic / Discharging - CS Space x4 Bedienungsanleitung

You confirm the program with the enter-key and by pressing the enter-
key again, the charge current is flashing. Now set the charge current with
the -DEC/+INC-keys-keys according to the manufacturer's indication.
The values are saved with another pressing of the start/enter-key.
Now you have to set the flashing information displayed on the right
side according to the voltage of the LiPo battery and confirm it with the
enter-key.
Charging of LiPo-Batteries with the balancer program: This function
allows the balancing of the voltage of Litthium batteries when charging.
You have to connect the battery with additional balancer cable with
the charger. Charging t with this program is different to the "normal"
modes, cause the voltage of each cell of the battery is checked and will
be adjusted by a different charging current.
When discharging, you have to enter the cell end voltage according
to the manufacturer's indication. Normally it is 3.0 V per cell and you
should not underrun this voltage. To give you an idea the additional in-
formation of the number of cells can be helpful like 6.0V(2S) for 2 cells
or 9.0V(3S) for 3 cells. Please refer to the safety notes.
If you now press the start/enter-key for more than 3 seconds, the
selected process starts in a safe mode and your settings are checked.
The number of the cells detected by the charger are marked with "R"
and with "S" the number of cells you have entered. If both values are
the same, the display shows "ENTER". You can now start the charging
process by pressing the enter-key.
If the values are not the same, the charger beeps and you have to press
the Batt-Type/Stop-key. After that you can enter the correct number
of cells respectively the voltage.
To interrupt or to break off the charging process press the Batt.Type/
Stop-key.
The completion of the charging process is shown by a flashing "Full"
in the display.
Additional information to the different programs:
While charging or discharging you can display additional infor-
Akkutyp Ladestrom Spannung
mation: To see the basic settings and information regarding the
charger, press the -DEC/+INC-keys. When pressing the +INC-key.
Information of the connected battery is displayed, for example the
voltage of each cell when charging in the balancer program.
Attention: Please check that the basic setup of the charger has
Ausgewähltes Eingeladene
already been done and that the battery type correspond to the
Programm Kapazität
selected charging program!
Ladezeit
11. Li-Ion Batteries – Charging / Balance-Charging/

Fast-Charging / Storage-Automatic / Discharging

The necessary basic settings for Lithium Ion batteries have to be entered in the USER SET
program of the CS-Space X4 Charger. Select with the Batt.Type key "USER SET PROGRAM" and
confirm it with the Enter-key. Now change the displayed setting of LiPo V.Type 3.7V by pressing
the START/ENTER-key and the -DEC/+INC-keys to LiIo V.Type 3.6V. Save the change by pressing
the START/ENTER-key.
12