EuroLite DMX SUPERSTROBE 2700 Bedienungsanleitung Seite 20

DMX-512 connection / connection between the strobes
For DMX-control, DIP-switch no. 10 has to be set to OFF.
The two 3-pin XLR connectors are for the DMX system. The device needs two channels to control it.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
Caution: The DMX SUPERSTROBE 2700 cannot be controlled via a 10V signal
Strobe addressing
You have to address every strobe to the respective starting address. Otherwise, the channel assignment will
not be correct. All strobes with the same starting address work synchronically.
The occupation of the Dip-switches is as follows:
Strobe Starting address
Strobe 1 1
Strobe 2 3
Addressing
Each device occupies 2 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Strobe Starting address
Strobe 3 5
Strobe 4 7
20/43
Strobe Starting address
Strobe 5 9
Strobe 6 11
00025936.DOC, Version 3.5