Installation - EuroLite DMX SUPERSTROBE 2700 Bedienungsanleitung

INSTALLATION

Preparation of the flash-tube
All packaging material has to be removed from the flash-tube before taking the device into operation.
Procedure:
Step 1: Unscrew the fixation screws of the protective shield.
Step 2: Remove the protective shield.
Step 3: Remove all packaging material from the flash-tube.
Step 4: Replace the protective shield and tighten the screws.
Rigging
Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the strobe has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The strobe should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the strobe. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The strobe has to be installed out of the reach of people.
If the strobe shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The strobe must never be fixed swinging freely in the room.
Caution: Strobes may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the strobe!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the strobe's
weight.
DANGER TO LIFE!
18/43 00025936.DOC, Version 3.5