Herunterladen Inhalt Inhalt Diese Seite drucken

Getting Started; Introduction; Battery Charging; First Flight Preparation - XciteRC Flybarless Trainer 175 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Introduction

As you are about to see, the Xcite Flybarless Trainer 175 truly is an ultra micro heli experience unlike any oth-
er. Its advanced flybarless design reduces drag on the rotor head and more importantly, under the precision
EN
in the three-axis gyroscope complement of self-control, it greatly increases stability of the body. This, com-
bined with its exceptionally lightweight airframe, delivers a level of power and responsiveness that eclipses
that of any ultra micro heli you have flown before.
Before you take the first flight, please take time to read through this manual. lt contains important pre-flight
information as well as useful tips on binding your transmitter that will help ensure your first flight is a great one.
Helicopter Parameters
Length
High
Weight
Rotating propeller diameter
TailRotor blade Diameter
Battery Specification
Flight time

Battery charging

• Connect charger to the USB port of computer by using USB Line.
• Connect the Li-po battery to the Charger by using Charger conversion wire, at this time. the charging
indicator light shows red. When the battery is full, the light turns green.
• The Charger can charge two batteries at the same time, and if no battery connect, the green light bright.
Notice: Only use the charger delivered with the helicopter.
WARNING: Never attempt to power the charger from an AC outlet without the use of a proper ACto DC
adapter/power supply. - fire hazard!

First Flight preparation

• Make sure the battery power Is full both for TX and helicopter
• Before open the power of TX, please make sure the TH. Stick at the bottom and the switch of TH.HOLD
and 3D mode in back position (back cover direction)
• Make sure the TX is binding with helicopter, or please rebind them.
• Please open TX first, then connect the battery with the RX board on helicopter to bind with TX. When
close, please cut the power of helicopter first, and then turn off the TX.
• Flying in a suitable area, away from people, cars, electric pylon, pool and so on.
16
200 mm
80 mm
35 g
204 mm
36 mm
3.7 V 180 mAh 15C
5 to 6 min

Getting started

13000000 XciteRC Flybarless Trainer 175

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis