Insert The Batteries; Getting Started - XciteRC 30600000 Bedienungsanleitung

Insert the batteries · Getting started

Insert the batteries:

NOTE: use only rechargeable batteries for the vehicle, no alkaline batteries! With alkaline batteries the
correct operation is not guaranteed.
WARNING: Make sure to read all safety instructions regarding the use of rechargeable batteries. Also,
if necessary, further safety instructions in the manual for your used charger.
WARNING: insert batteries / rechargeable batteries with the correct polarity - fire or explosion ha-
zard!
The contacts of the battery holder in the vehicle can fail by frequently changing the batteries. You recognize
that in short breaks while driving. Slightly turn them into contact with a screwdriver so that they fit correctly
to the battery cells!
+
-

Getting started

Before you start, check all functions of the remote control. Does the vehicle follow exactly and directly your
commands? Or does it react delayed or choppy? If yes, do not start anyway, but check transmitter and drive
batteries and recharge or replace if necessary.
The run time of your Twenty4 depends on the surface. The maximum run time is reached on a straight and
levelled surface. In hilly terrain or grass, the run time is much shorter, also the motor, speed controller and bat-
tery gets much warmer. If the battery is weak, the vehicle first gets slower until it finally stops completely. To
increase the life time of the drive battery, you should cease operation when the vehicle begins to slow down.
1. Switch on the transmitter, ON/OFF-switch in position I.
2. Switch the vehicle ON.
to connect the transmitter with the reciever properly.
twenty4 series
-
+
Note: wait about 5 sec. before you move the throttle trigger. This is needed
ON
EN
21