Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.0 Transport
ATTENTION! Always check delivery for completeness and damage!
The carrier (forwarder or railway) is to be informed immediately in case of transport damages.
(s. yellow leaflet)
5.0 Setting up the machine
The drill should be set up on a solid base and aligned using a spirit level. If the machine is to be bolted to the base,
ensure that the base plate does not warp in the process. Use of vibration damping elements is recommended.
6.0 Installation
The machine has been installed ready for use. Please check whether type of current, current voltage and fusing
agree with the prescribed values. There must be a protective ground terminal. Mains fusing 16 A.
Attention! Take notice of the right rotation (right-hand) of spindle.
7.0 Commissioning
The parts with rust-inhibiting coating should be cleaned carefully. The column should then be lubricated. The table
should be moved several times since condensation may have formed in the table guide.
8.0 Operating and indication elements
(max. equipment) see figure 2
1. main switch
2. polarity/reverse switch (FB reverse switch)
3. emergency push button
4. coolant on/off
5. lighting on/off
9.0 Operating
For starting/stopping the machine switch on/off the main switch. Hereto first unlock the emergency push button
(optional). The electrical drill guard must be closed (safe position).
If present use the polarity/reverse switch to select the right speed level, now you can change from spindle speed
step 1 (right-hand) into spindle speed step 1 (left-hand) e.g. for tapping.
The return switch reverses the tuning direction of the spindle between r.h. and l.h. (e.g. threading)
10.0 Speed indication
10.1 On machines without a digital speed indication the set speed will be shown on a scale at the shifting lever
Machines with variable speed drive are preadjusted to speed level 1.
10.2 On machines with a digital speed indication the set speed will be shown ex actly on the display
(accuracy 10 rpm).
11.0 Speed change
11.1 On machines with a variable - speed drive open the hood (screw B), unmount indicator, clamping lever, shift
lever and left-hand hood (screw A). Untension the belt by unclamping the motor holder and switch belt to the
corresponding belt disc. Assembly in reve rse order.
11.2 On machines with a mechanical infinitely variable - speed drive change the speed by swivelling the shifting
lever when the machine is running.
11.3 On machines with a electronical infinitely variable - speed drive change the speed by turning the
potentiometer.
12.0 Drilling depth indication
12.1 On machines without a digital drilling depth indication the drilling depth is shown on a scale.
12.2 On machines with a digital drilling depth indication the set drilling depth is shown digitally.
13.0 Adjusting the drilling depth
Adjusting drilling depth without digital depth indicator move pinion to drilling depth, clamp limitor (4) and drill
backwards to zero. The clamp limitor (4) can be used as fixed backstop. Move the pinion to drilling depth and
clamp limitor (4). Now the drilling depth can be adjusted ± 3 mm using by using nut (2). One turn of this nut
corresponds to 1,75 mm. The drilling depth should be checked and corrected after having made one test hole.
see figure
5
205286 D/GB
GB
8
Werbung
