Repairs; Troubleshooting - BOMANN DU 659 IX Bedienungsanleitung

Cleaning the aluminium grease filter
WARNING: Risk of fire!
Grease residues in the aluminium grease filter may ignite on exposure to high temperatures. It is therefore impor-
tant that the grease filter are regularly cleaned / replaced.
Grease and vapours collect in the filter and may accumulate if not regularly cleaned. We recommend that you clean the grease filter monthly:
• Remove the aluminium grease filter by sliding back the lock in the handle recess, push the filter down gently and pull out towards the front.
• Rinse the grease filter in a solution of hot water and neutral detergent. Soak the grease filter in the solution.
• Then clean with a soft brush, rinse thoroughly with hot water, and leave to dry.
• Alternatively, the grease filter can also be cleaned in the dishwasher (up to 60°C). Slight discolouration may occur in the dishwasher. This does
not affect the function of the grease filter.
Replacing the activated carbon filter
The activated carbon filter absorb odours and must be replaced at least every six months, depending on use. Order the carbon filter from your dealer
or in our online accessories shop, www.bomann.de. To order, use the reference number found under "Technical Data".
• See "Installing activated carbon filter for recirculation mode".
• Remove the old carbon filter by turning the filter anti-clockwise.
Replacing the lighting
WARNING:
Allow the lamps to cool before replacing the lighting. Risk of burns!
• Use the correct lighting: 2 x 20 W Halogen lamps (Type G4)
• Carefully remove the lamp ring with a suitable tool.
• Change the lamp.
• Replace the lamp ring.
A wrong or improperly performed repair brings danger to the user.
Repairs to electrical appliances must only be carried out by an authorized specialist. A damaged power cord must be changed only by a qualified
electrician.
Before you contact an authorized specialist
The following problems can be solved by you by checking for the possible cause.
Problem Possible cause
The appliance is not working -
or does not work properly -
The appliance does not run -
efficiently
- Are the grease filter dirty?
- Are the carbon filter needed for recirculation (correct-
- Is the air outlet required for extraction mode clear?
The lighting does not work The lighting is faulty, was incorrectly installed, lamp not
secure in the fitting.
Oil dripping from appliance The grease filter are dirty.
NOTE:
If a problem still persists after following the steps above, contact your distributor or an authorized technician.

Repairs

Troubleshooting

Is there power supply to the appliance?
Have you set the power level?
Have you selected the correct power setting?
ly) installed?
Solution
- Connect to the mains. Check the distribution board.
- Check the setting.
- Check the setting. The kitchen is not properly venti-
lated.
- Clean the grease filter (see "Cleaning the aluminium
grease filter").
- Check the carbon filter (see "Replacing the activated
carbon filter").
- Check the air outlet.
Check the lighting (see "Replacing the lighting").
Clean the grease filter.
15 15