Unpacking The Appliance; Appliance Overview; Supplied Parts; Installation - BOMANN DU 659 IX Bedienungsanleitung

Dunstabzugshaube cooker hood

Vorschau ausblenden Andere Handbücher für DU 659 IX:

Bedienungsanleitung (28 Seiten)

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

• Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure

to danger, always have faulty cable be replaced only by the manufacturer, by our customer service or by quali-

fied person and with a cable of the same type.

1. Remove the appliance from its packaging.

2. Remove all packaging material, such as foils, filler, cable holder and cardboard packaging.

3. To prevent hazards, check the appliance for any transport damage.

4. In case of damage, do not put the device into operation. Contact your distributor.

NOTE:

Production residue or dust may have collected on the appliance. We recommend cleaning the appliance according to chapter "Cleaning and Mainte-

nance".

NOTE:

The original appliance may differ from the appliance pictured here.

Supplied parts

1 x external duct without ventilation slots

2 x non-return valves

There must be a safety distance between the hotplate of the cooking pot on the hob and the bottom part of the extractor hood:

The distance must be between 45 – 55 cm. For gas appliances, the distance must be at least 65 cm. If the installation instructions for the gas

cooker specify a greater distance, this distance must be taken into consideration.

Selecting the fume outlet

You can operate the extractor hood in two modes:

Extraction mode

WARNING:

• The extracted air may not be vented into a flue which is used for the waste gas from appliances which are pow-

ered by gas or other fuels.

• When venting the extracted air, comply with the regulations of the relevant local authorities.

The hood has an upper air outlet to vent cooking odours to the outside.

• The extracted air is normally vented vertically. If there is a suitable loft space above your kitchen, the extracted air is vented through the wall units

and the loft floor to the roof ridge.

• If there is a conduit in your kitchen under the wall units, the extraction duct can be routed so that the extracted air can be vented horizontally

through the wall.

Recirculation mode

If you do not have a direct extraction vent to the outside; the hood can also work in recirculation mode (i.e. without an extraction vent to the outside; the

filtered air is released back into the room). In this case, two activated carbon filter as described under "Installing the activated carbon filter for recircula-

tion mode", must be used.

12 12