Introduction; Unpacking; Positioning; Connection - Dali MOTIF LCR Handbuch

1 . 0 I N T R O D U C T I O N
congratulations on your new fine DALI FAZON SuB 1 subwoofer. Please read this manual thoroughly
before unpacking and installing the subwoofer in order to get most from your purchase. You can
find more information on our website: www.dali-speakers.com or by contacting your authorised
DALI dealer.
2 . 0 U N P A C K I N G
Be careful not to damage the contents when unpacking the parts (see figure 1). check that all
parts are included in the cardboard box (see figure 1). Keep the packaging materials in case your
speaker needs to be relocated or serviced.
3 . 0 P O S I T I O N I N G
Both the amount and quality of the deep bass depend on the size and shape of the room, the
position of the subwoofer(s) and the main speakers. If positioned near a side or back wall, the
bass will be accentuated. A corner position will accentuate it even more, and we recommend
this position, as it increases the maximum bass output while simultaneously reducing the risk of
overloading your subwoofer.
DALI FAZON SuB 1 features a down-firing woofer, which is elevated from the floor by means of
the integrated feet of the subwoofer.
NOTE: Placing the subwoofer on a thick carpet may prevent a free flow of air, resulting in a loss
of sound quality.
Located at the rear side of the subwoofer is a heat sink, which can become hot when the subwoofer
is powered. Prevent the heat sink from being blocked or covered. Ensure a minimum distance of 5
cm/2" between the heat sink and the nearest obstacle to secure free airflow around the heat sink.
4 . 0 C O N N E C T I O N
DALI FAZON SuB 1 has a built-in power amplifier with an active crossover. the inputs of the
subwoofer amplifier should be connected to your stereo or surround sound (pre-)amplifier using
a RcA cable (sold separately). When changing connections, always disconnect the mains voltage
from the subwoofer to prevent damage.
the subwoofer can be connected to your stereo or surround sound amplifier in two ways:
1) LINE input: the signal from the amplifier is low pass filtered inside the subwoofer using
one or both of the LINE INPutS. this way of connecting the subwoofer is typically used for
connecting to a stereo amplifier/receiver.
2) LFE input: the signal from the amplifier is filtered inside the amplifier using the R/LFE input
connector. this way of connecting the subwoofer is typically used for surround sound (A/V
receiver) setups.
NOTE: When the subwoofer is connected to the music/home cinema system, don't power up
the subwoofer until all other components are all "on".
8