Troubleshooting - Sony PMC-D40L Bedienungsanleitung

Troubleshooting

Symptom
There is no audio.
Noise is heard.
"no disc" lights in the display even
when a CD is in place.
The CD does not play.
The sound drops out.
The audio is weak or has poor
quality.
The audio is not stereo.
The picture of your TV becomes
unstable.
Remedy
• Press OPERATE to turn on the player.
• Connect the AC power cord to a wall outlet
securely.
• Connect the power cord to the POWER IN of
the player (page 26).
• Connect the audio connecting cord correctly
(page 27.)
• Adjust the volume.
• Unplug the headphones when listening through
speakers.
• Someone is using a portable telephone or other
equipment that emits radio waves near the
player. n Move the portable telephone, etc.,
away from the player.
• Insert the CD with the label surface up.
• Make sure that the CD compartment is closed.
• Place the CD with the label surface up.
• Clean the CD.
• Take out the CD and leave the CD compartment
open for about an hour to dry moisture
condensation.
• Press p on the CD section to switch the function
of the player to "Cd".
• Reduce the volume.
• Clean the CD, or replace it if the CD is badly
damaged
• Place the player in a location free from
vibration.
• Move the player away from the TV.
• If you are using the remote while listening to
MW/LW radio, noise may be heard. This is
unavoidable.
• Press PLAY MODE/MONO/ST/ISS on the
player until "STEREO" appears.
• If you are listening to an FM program near the
TV with an indoor antenna, move the player
away from the TV.
continued
Additional Information
35 GB