Channel-Section; Channel Control - Omnitronic RS-602 Bedienungsanleitung

5.2 Channel-section

GAIN
1
With the GAIN-control, you can set the level of the input signal. The control range is
MIC
between 10 and 60 dB for the microphone signals and +10 to –40 dBu for the line
signals. The most common working levels are –10 dBV and +4 dBu marked on the
scale.
Please refer to Adjusting the input level.
HIGH
With the HIGH-control, you can increase or lower the treble of the input signal at the
respective channel. This is a 12 kHz shelving equalizer with a control range of ±15 dB.
LINE
MID
With the MID-control, you can increase or lower the mids of the input signal at the
GAIN
-10
respective channel. This is a 12 kHz shelving equalizer with a control range of ±15 dB.
LOW
+4
With the LOW-control, you can increase or lower the bass of the input signal at the
respective channel. This is an 80 Hz shelving equalizer with a control range of ±15 dB.
AUX
With the AUX-control, you can control the signal sent to the AUX SEND-socket. The
signal is post-fader and can be used for effectors etc. Turned fully to the left, no signal
0
EQ
is routed to the AUX SEND-socket. In the center position, the incoming signal is routed
without any changes and between 0 and +10 dB it is enforced, respectively.
HIGH
12 kHz
PAN
-15 +15
0
With the PAN-control, you can position the signal of a mono input in the stereo output.
The signal level remains constant.
MID
2.5 kHz
BAL
-15 +15
0
With the BAL-control, the signal portion of a stereo input is routed to the left or to the
right.
LOW
80 Hz
-15 +15

Channel control

0
AUX
With the channel control, you can adjust the signal level of the respective input channel
in the mix.
-
+10
PAN
PEAK
L R
0
- +10
LEVEL
1
18/23 10040050_V_1_1.DOC