Danger To Life; Dmx-512 Connection / Connection Between Fixtures - EuroLite LED T-36 RGB Bedienungsanleitung

Mount the Pinspot with the mounting-bracket to your trussing system using an appropriate clamp.
or:
Mount the Pinspot with the mounting-bracket to the desired installation spot.
Do only use an appropriate screw and make sure that the screw is properly connected with the ground.
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the hole in the
mounting-bracket and over the trussing system or a safe fixation spot. Insert the end in the quick link with
screw cap and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.

DANGER TO LIFE!

the fixtures will not work at all, or will not work properly.
17/39
(1) Trussing
(2) Hook
(3) Mounting-bracket
(4) Fixation screw
(5) LEDs
(6) Pinspot housing
(7) Safety-rope hole
(8) Safety-rope
(9) Quick link
51913580_V_1_1.DOC