Sony KV-28FC60Z Bedienungsanleitung Seite 13

Operation
Using the Individual Setting menu
When you select
individual selection of themes, limiting the search to the marked ones.
1 Select using 4 or $. Push to " to enter.
The Individual Setting menu is displayed.
2
Select the item you wish to mark using 4 or $. Confirm by pressing OK.
Repeat step 2 for all items you wish to have in your list.
3
When you have finished the list, press " to select
Using the Long Info menu
1 Select a future programme in the column programme list using 4 or $. Press OK.
The long info menu is displayed.
07 Tue
12:38
You wish to record the selected programme with your VCR
(only with Smartlink VCRs)
2 Select using " and press OK.
The information is transferred to the VCR connected to your TV set.
Setting up your VCR
3 Select VPS/PDC pushing repeatedly to ".
With this setting on, you have the guaranteed recording of the whole broadcast should
there be a change in the TV programme. This only works if the selected channel
broadcasts a VPS/PDC signal.
•
Select On or Off using OK.
4 Select Speed using $.
Select between standardplay (SP) or longplay (LP) mode. With longplay you can record
twice as much on a videotape. The picture quality, however, may suffer.
•
Select SP or LP using OK.
5 Select VCR Setup using $.
Select with which of the connected Smartlink-VCRs you wish to programme.
•
Select VCR 1 or 2 using OK.
To leave the menu
6 Select using z. Press OK.
You are back in the last menu.
there will be no personal pre-selection.
First nextTView/EPG-Providers in Europe
SWISS TXT TPS / RINGIER
Tue 07. 04 .98
Address Mapping
The position of the addresses in the
OSDA is shown in the following diagram.
The position values of the DPW are set
to '0'.
If other values are set, the complete
combination will be scrolled.
Example:
if the DPWC is set to '63', the char-
This channel has been set for a timer
VPS/PDC On
Speed SP
Timer Prog VCR1
lets you make your own
on the menu screen then press OK.
nexTView
VPS/PDC On
Speed SP
VCR Setup VCR1
11