Herunterladen Inhalt Inhalt Diese Seite drucken

Functional Instructions; Features And Operational Controls - Hifonics Atlas Series Benutzerhandbuch

Hybrid class a/b & d 5-channel amplifier
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

FEATURES AND OPERATIONAL CONTROLS

The LINE IN & SUB IN RCA jacks must be connected with the RCA output jacks of the headunit.
1
Please check also the notes in section #15 on the right.
HI LEVEL INPUTS & AUTO TURN ON
2
If your head unit has no pre-amplifier low level RCA outputs or doesn't provide a separate remote turn on wire (like described on
page 19/#2), follow these instructions:
High level speaker cables as signal input:
Please use the optional HF-HLA adaptor from HiFonics (see
page 28). This adaptor is optmized for the use with this amplifier
inputs and owns additionally a protect function for the speaker
outputs of your headunit.
Alternative: Solder the ends of the loudspeaker cables of the
head unit with common RCA connectors (separately available)
and connect them with LINE IN of the amplifier.
The HI LEVEL INPUTS can be use independently from the
AUTO TURN ON function.
AUTO TURN ON
Bring the AUTO TURN ON switch to position ON to activate the auto turn on function. This function only works, if the push button
INPUT LEVEL MODE is in HI position, the switch INPUT MODE in 2CH position and highlevel inputs (speaker outputs from the
headunit) are connected at the LINE IN CH1 & CH2. Please check the regarding notes below.
The amplifier detects now by the so called "DC Offset" (a voltage increase to 6 volts on the high level speaker outputs) if the
head unit is turned on and the amplifier turns automatically on. As soon as the head unit is turned off, the amplifier shuts down
automatically after approx.one minute.
NOTE: The AUTO TURN ON usually works with 90% of all headunits, because they are equipped with the "High Power" outputs.
Only with a few older headunits the AUTO TURN ON function is not applicable.
The port of the remote connector of the amplifier (page 19#2, REM) can now be used also to turn on additional other amplifiers.
Connect the REM ports of the amplifiers and ensure, that the other amplifier's AUTO TURN ON function is deactivated.
20

FUNCTIONAL INSTRUCTIONS

2
AUTO TURN ON
(ONLY IN HI LEVEL INPUT MODE)
CH1
CH3
CH5
CH2
CH4
LOW
INPUT
LINE IN
SUB IN
1
BRIDGED
BRIDGED
CH1
CH2
CH3
SPEAKER
OUTPUT
ARX5005
3
4
5
X-OVER
HP
LEVEL
HP/BP
CH1/CH2
OFF
HP
FULL
50Hz
4kHz
MIN
MAX
50Hz
ON
HI
35Hz 150Hz
15Hz 55Hz
0dB
18dB
MIN
LP
SUB SONIC
BASS BOOST
LEVEL
LEVEL
10 11 12 13 14 15
GND
REM
CH4
POWER INPUT
6
7
8
9
X-OVER
LP
LEVEL
CH3/CH4
HP
FULL
LP /BP
250Hz
150Hz 4kHz
MIN
MAX
POWER
INPUT MODE
MAX
PROTECT
2CH
4CH
5CH
CH5
BASS LEVEL
CONTROLLER
16
+12V
CH5
SUB
OUTPUT
FUSE
CORE CONDUCTOR
SPEAKER CABLES
LOG0
BLUE / WHITE
TO THE LINE IN ON THE
AMPLIFIER
SHIELD

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Arx5005

Inhaltsverzeichnis