Functional Instructions; Features And Operational Controls - Hifonics Zeus Serie Benutzerhandbuch

FEATURES AND OPERATIONAL CONTROLS

1 2
The TWIN SUB switch in position ON effectuates, that the bass remote controller adjusts the level simultaniously on both chan-
1
nel pairs (CH1/2 & CH3/4) in mono-bridge mode with two subwoofers. Also all crossover settings (BASS BOOST, LP/BP, HP,
LEVEL, X-OVER) of CH3/4 will be synchronized with CH1/2. In switch position OFF, the bass remote works only on CH3/4.
POWER/PROTECT
2
If the POWER LED lights up, the amplifier is ready for operation.
If the PROTECT LED lights up, a malfunction is indicated. Refer in this case to the chapter TROUBLE SHOOTING.
The CH1/2 and CH3/4 BASS BOOST controllers adjust the bass boost enhancement continuously from 0dB to +18dB at
3
45 Hz for the relevant channels (Channel 1/2 or 3/4).
The X-OVER CH1/2 and CH3/4 switch selects the required operation mode of the amplifier on the regarding channels (Channel
4
1/2 or 3/4).
LP/BP: Lowpass mode (The higher frequencies will be eliminated. Adjustable by the lowpass controller.)
The HP/BP controller works in this operation mode as subsonic filter and eliminates the lower frequencies (Bandpass-Mode).
NOTE: If this controller is turned to a higher value than the lowpass controller, no sound is hearable.
HP: Highpass mode (The lower frequencies will be eliminated. Adjustable by the HP/BP controller.)
FULL: Fullrange mode (The whole frequencies will be amplified).
The CH1/2 and CH3/4 LP controllers adjust the cut-off point of the frequency range to above for the relevant channels (Channel
5
1/2 or 3/4). The cut-off frequency is continuously adjustable from 30 Hz to 150 Hz.
The INPUT MODE switch must be in 2CH position, if you connect only one RCA stereo audio cable with the CH1/2 line inputs.
7
Select the position 4CH, if you connect two RCA stereo audio cables with the CH1/2 and CH3/4 line inputs. The fader function
of your head unit works only in the 4CH mode.
If you have selected the 2CH mode, the input signal of LINE INPUT CH1/2 will be routed to the channels 3 and 4. This means
only one RCA stereo audio cable is required. When you operate two subwoofers, you can also use the subwoofer output from
the head unit in this configuration.
The BASS LEVEL CONTROLLER port is for the enclosed bass remote in LP/BP mode. With this bass remote controller you
7
are able to adjust the bass level e.g. from the driver's seat. Please connect only the enclosed bass remote controller and cable.
20

FUNCTIONAL INSTRUCTIONS

TWIN CH1/2
X-OVER
BASS BOOST LP
SUB
MODE
OFF
0dB 18dB LP/BP HP FULL
30Hz 250Hz
ON
BASS BOOST LP
X-OVER
POWER
MODE
0dB 18dB
30Hz 250Hz
LP/BP HP FULL
PROTECT
CH3/4
3 4 5
GND REM +12V
POWER INPUT
INPUT
HP/BP LEVEL
LEVEL
INPUT MODE
4CH 2CH
LOW
10Hz 1.2kHz MIN MAX
HI
HP/BP LEVEL
OFF
ON
BASS LEVEL 10Hz 1.2kHz MIN MAX
CONTROLLER
AUTO TURN ON
(ONLY IN HI LEVEL INPUT MODE)
6 7 8
BRIDGED
CH1
SPEAKER
FUSE
ZRX9404
CH1 CH3 L
CH2 CH4 R
LINE IN LINE OUT
9 10 11
BRIDGED
CH2 CH3 CH4
OUTPUT
12
LOG0
BLUE / WHITE