Functional Instructions; Features And Operational Controls - Hifonics Zeus Serie Benutzerhandbuch

FEATURES AND OPERATIONAL CONTROLS

1 2
POWER/PROTECT
1
If the POWER LED lights up, the amplifier is ready for operation.
If the PROTECT LED lights up, a malfunction is indicated. Refer in this case to the chapter TROUBLE SHOOTING.
The LOGO push button switches the logo illumination on the upper side from blue to white.
2
The BASS BOOST controller adjusts the bass boost enhancement continuously from 0dB to +18dB at 45 Hz.
3
The X-OVER switch selects the required operation mode of the amplifier.
4
LP/BP: Lowpass mode (The higher frequencies will be eliminated. Adjustable by the LP controller.)
The HP/BP controller works in this operation mode as subsonic filter and eliminates the lower frequencies (Bandpass-Mode).
NOTE: If this controller is turned to a higher value than the lowpass controller, no sound is hearable.
HP: Highpass mode (The lower frequencies will be eliminated. Adjustable by the HP/BP controller.)
FULL: Fullrange mode (The whole frequencies will be amplified).
The LP controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is continuously adjustable from
5
30 Hz to 250 Hz.
The BASS LEVEL CONTROLLER port is for the enclosed bass remote in LP/BP mode. With this bass remote controller you
6
are able to adjust the bass level e.g. from the driver's seat. Please connect only the enclosed bass remote controller and cable.
The HP controller adjusts the cut-off point of the frequency range to below. The cut-off frequency is continuously adjustable from
7
10 Hz to 1200 Hz (1.2 kHz).
20

FUNCTIONAL INSTRUCTIONS

LOG0 BASS BOOST X-OVER
PROTECT
MODE
POWER BLUE / WHITE
0dB 18dB LP/BP HP FULL
ZRX4002
3 4 5
GND REM +12V
POWER INPUT
LP HP/BP LEVEL
30Hz 250Hz 10Hz 1.2kHz MIN
AUTO TURN ON
BASS LEVEL
(ONLY IN HI LEVEL INPUT MODE)
CONTROLLER
OFF LOW
ON HI
6 7 8
FUSE
ZRX4002
L L
MAX
INPUT
LEVEL
R R
LINE IN LINE OUT
9 10 11
BRIDGED
L R
SPEAKER OUTPUT