Addressing; Connection With The Mains - EuroLite SL-1200 LD Follow Spot Bedienungsanleitung

Addressing

Each projector occupies 4 channels. To ensure that the control signals are properly directed to each
projector, the projector requires adressing. This is to be done for every single projector by changing the DIP
switches as set out in this table.
The starting address is defined as the first channel from which the SL-1200 LD will respond to the controller.
If you set, for example, the address to channel 5, the SL-1200 LD will use the channel 5 to 8 for control.
Please make sure that you don't have any overlapping channels in order to control each SL-1200 LD
correctly and independently from any other fixture on the DMX data link. If two, three or more SL-1200 LD
are addressed similarly, they will work similarly.
Occupation of the DIP-switches:
Setting the DMX-
starting address:
Projector number
& channels
Device 1 - channels 1-4
Device 2 - channels 5-8
Device 3 - channels 9-12
Device 4 - channels 13-16
Device 5 - channels 17-20

Connection with the mains

The electric connection must only be carried out by a qualified electrician!
In order to connect the device to the mains, you have to install a power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Connect the device to the mains with the power-plug.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.
1
DIP-switch no.
DMX-starting
1
address
On
Off Off
On
Off
On
Off
On
Off
On
Off
DANGER TO LIFE!
International
L
N
2 3 4 5 6
2 4 8 16 32
24/51
7 8 9
64 128 256
51787360_V_1_2.DOC