Maintenance; Restriction Of Use; Getting Started - WOLFF TANGO Original Bedienungsanleitung

WOLFF cannot be held responsible for any damage or
loss caused by incorrect use Correct use also includes
to take care of all directions from the operating
manual and
the execution of maintenance and service.
02/2010 Einscheibenschleifmaschine TANGO, #056366

3.3 Restriction of use

The Monodisc grinding machine TANGO is exclusively for wet-
cleaning and polishing of resilient and textile floor coverings, and
for grinding pavement and levelling compounds in dry environ-
ments. It should not be used for any other purpose.
3.4 Genuine Spare Parts
Spare parts and accessories are manufactured uniquely for the
Grinding machine TANGO. It must be emphasized that parts
obtained from unauthorized sources must not be used.
WOLFF cannot be held responsible for the performance of or
any damage arising from the use of machines in which genuine
spare parts have not been used. This is particularly important with
mounting discs, discs and brushes.

4.0 Maintenance

The Monodisc grinding machine TANGO is virtually maintenance-
free. The roller bearings and gear box need not to be lubricated.
Mounting and changing the paper bags of the vacuum unit
The vacuum unit can be used with paper bags, or, with the
enclosed textile bag.
Pos. 16
5.0 Use

5.1 Getting started

The Grinding machine TANGO is shipped in 2 boxes. Mount the
handle with 4 screws, safety washers and nuts to the machine.
(Pos 16) Connect the power cord of the handle with the machine.
Assembly of mounting discs, pads and brushes
Lay the machine down on the handle. Thus the support of the
discs is accessible. Put the mounting disc on the actuation and
lock it by turning anti-clockwise.
Assembly of the vacuum unit
Assemble the vacuum unit with 2 supports to the handle.
The upper plastic mounting can be shifted by loosening the screws.
release and pull the cover of the vacuum unit upwards
insert paper bag
remount the cover
mount the vacuum ring from the lower side of the machine
connect the vacuum ring with the vacuum unit with the tubes
connect the power cord of the vacuum unit with the
grinding machine
insert lower connector into the plastic mounting
lock the upper connector by shifting the upper plastic
mounting down
12