Maintenance; Use - WOLFF 038588 Original Bedienungsanleitung

Lubricator nipples
1
52
53
EXTRO-STRIPPER 2, 230 V #038588, 115 V

4.0 Maintenance

The EXTRO-STRIPPER is virtually maintenance-free. Have the
guides of the swing bolts lubricated from time to time (after
approx. 500 square meters).
The lubricator nipples are located collateral on the front side
(see picture). The used grease will flush dirt out of the machine.
Press maximum 3 to 4 times with the grease gun. Never press
too much grease into the machine. Otherwise the mechanism
will be blocked.
Changing the blade
Disconnect the power supply before changing the blade. Use
work gloves for your own safety.
Put the handle on highest position , (see chapter 5,3)
Fold up column and tip the machine
put on the blade protection (enclosed in the tools set)
Warning! Very sharp blade! You may cause injury without
using the blade protection!
secure the tipped machine from tilting over
clean and loosen the screws of the blade mounting,
Attention! Set the wrench at a position opposite to the
blade to avoid injury.
2
replace the blade.
Make sure that the blade fits in exactly into the support. On
normal and hard subfloors the bevel of the blade should show
upwards (1), on soft subfloors (e.g. chipboards) the bevel should
show downwards (2).
Changing the driving wheels
Remove the splint-pins and pull the wheels from the axle. Do not
32
loose the springs (Pos. 53) under any circumstances!
30

5.0 Use

The EXTRO-STRIPPER removes any bonded floor coverings in
strips. This procedure corresponds with the customary method
of using a hand floor scraper. The stripper works with a thin steel
blade at very high frequency, minimizing vibration and noise.
The EXTRO-STRIPPER is self propelled. The motor actuates
both the blade and the machine movement. The blade drive
starts as soon as the machine is switched on. The hand clutch
will engage the drive.
#039121,RÄSM
12