Technical Data; Declaration Of Conformity; Safety Instructions - WOLFF TANGO Original Bedienungsanleitung

1.0 Technical Data

Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .230V
Power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . .1000 W
No-load speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .154 r.p.m.
Sound pressure level . . . . . . . . . . . . . . . . . . . . . . . . . .54 dB(A)
Sound energy level . . . . . . . . . . . . . . . . . . . . . . . . . . .67 dB(A)
Hand/Arm-Vibration . . . . . . . . . . . . . . . . . . . . . . . . . .< 4,5 m/s2
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .41 kg
Diameter of discs . . . . . . . . . . . . . . . . . . . . . . . . . . . . .375 mm
2.0

Declaration of Conformity

We declare under our sole responsibility that this product is in con-
formity with the following standards of standardization docu-
ments:DIN EN 1037, EN ISO 12100, DIN EN 60204-1, DIN EN
60745-1, DIN EN 55014-1, DIN EN 55014-2
according to the provisions of the: 2006/42/EC, 2004/108/EC,
2006/95/EC.
Dipl.-Ing. (FH) Dieter Hammel
Authorised to issue this declaration and for the
gathering of the technical documentation.
10.02.2015 i.V.
WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1

3.0 Safety instructions

Disconnect the power supply before any maintenance is carried
out. Use only recommended mounting discs and brushes. The
mounting discs must have a plain surface.
Use only genuine WOLFF discs and brushes. Other parts could
affect the safety of the machine.
Maintenance should be undertaken only by qualified personnel.
Use only genuine WOLFF spare parts. Use only appropriate
detergent liquids. Both of them must be in perfect condition, the
insulation must not be damaged.
Have damaged insulation repaired at once, before starting the
machine.Otherwise this may result in considerable danger to the user.
3.1 Introduction
This operating manual should be used to get the most benefit
from your Monodisc grinding machine TANGO. Following these
instructions will both extend the life of your machine and reduce
repair costs.
Please ensure any user of the machine is fully familiar with the
instructions for use before allowing work to start.
3.2 Danger while working with the machine
The Monodisc grinding machine TANGO is designed to the hig-
hest technical standards. Incorrect use can be dangerous! with
the machine in perfect working order.
Disturbances that could impair safety, have to be eliminated at once.
02/2010 Einscheibenschleifmaschine TANGO, #056366
Comes with:
Monodisc grinding machine TANGO,
Tool kit
Operation manual
Check the power cord and the plug before starting.
Use this machine only
as instructed in this operating manual
with the machine in perfect working order.
FRÄSMASTER
11