Care And Cleaning; Cleaning The Filter - AEG TP6060TW Benutzerinformation

and Anti-crease (Knitterschutz)
buttons for approximately 2 seconds.
10.3 Deactivating the Water
container (Behälter) indicator
The water container indicator is by
default on. It starts to light at the end of
the drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.

11. CARE AND CLEANING

11.1 Cleaning the filter

At the end of each cycle the indicator
Filter (Sieb) is on and you must clean the
filter.
The filter collects the fluff.
The fluff occurs while the
cloths are dried in the
tumble dryer.
1. Open the door. Pull the filter.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus (Trocken+) and
Buzzer (Signal) buttons.
One of 2 configurations is possible:
• the Water container (Behälter)
indicator: is on and the symbol
goes into the view - the
water container indicator is
permanently on
• the Water container (Behälter)
indicator: is off and the symbol
goes into the view - the
water container indicator is
permanently off
2. Push the hook to open the filter.
3. Use a moist hand to clean both parts
of the filter.
4. If necessary clean the filter with the
brush under warm tap water and/or a
vacuum cleaner. Close the filter.
ENGLISH 17