Independence Freestyle One Betriebsanleitung Seite 12

3. Fold the canopy in big, horizontal S-folds (stack pack). Bundle the lines in 3x3 "8-folds". Do not bundle the last 50 cm of
lines.
Attention: new rubber bands must be used for line bundles with every re-pack!
4. Close the deployment bag with the lines. First the
lower flap with the upper flap.
Depending of the rescue system size the inner or outer
grommets can be used to adjust the deployment bag
volume.
2.2. Mouting the deployment bag into the harness:
Freestyle Two only:
For the 2nd rescue system a second Y-bridle set must be
built in on the rescue system connection.
We do not recommend to loop in the Y-bridle. It is
recommended to use 2 suitable quick links with a
minimum breaking load of together 2.400 daN. The sames
strenght is needed for the Y-bridle.
Secure this conneciton(for example by a neopren sleeve)
to avoid slipping (yellow arrow).
12
5. Close the left and right flap and secure it with the
lines.
Remove packing cord!
1. Guide the Y-bridle in the channel to the rescue
system container.
Close the zipper of the channel completely. Therefor
slide the slider fully from bottom to top.
Take care that zipper on the bottom (yellow circle) is
fully closed to avoid an unintentional opening.
Then close the velcro cover on top of the rescue system
conneticon.